Sale and Manufacture of Refractory Products
es | en

ALULOC 80 SR

CHECK IN AND CONSULT THE PRICE

Availability: In stock


Characteristics:


- Low cement refractory castable, based on high quality bauxite and corundum.


- Specific for the Aluminium Industry.




 Application:


- Product specially designed for the lining of holding and melting furnace vessels.


- Specially designed for in contact with molten Aluminium.


- Designed where low wettability by molten aluminium is required.

 


 


ALULOC 80 SR

Double click on above image to view full picture

Zoom Out
Zoom In

More Views

CHECK IN AND CONSULT THE PRICE

Insertec Technical Data Sheet

Humidity xxx
Caracteristicas Low cement refractory castable, based on high quality bauxite and corundum.
Application Specific for the ALUMINIUM INDUSTRY. Product specially designed for the lining of holding and melting furnace vessels, in contact with molten aluminium, and any other vessel where low wettability by molten aluminium is required.
Temperature 1.100 ºC.
Grain Size Distribution 0 – 6 mm.
Tipo de Ligante Modified Hydraulic.
Chemical Analysis Al2O3 - Aprox. 79,0 % ; SiO2 - Aprox. 10,5 % ; Fe2O3 - Aprox. 1,5 %
Density 2.800 Kg/m3
Installation Cast-vibration with needle vibrators. Do not prepare more material than the amount to be installed within 20 minutes.
Storage In a dry place, 12 months.
Packing In 25 kg. paper sacks, over shrunk - wrapped pallet.
Drying and Heating Follow specific instructions for each particular case. As a general rule: Hold for 24 hours before removing mould. Dry at 100-150 ºC for 12 - 36 hours. Heat up at a rate of 30 ºC/h. up to 450 ºC. Hold for 12 hours. Heat up to 600ºC at a rate of 30ºC/h an
Water Required Casting and Vibrating 5 – 6 % (depending on mixing conditions: outside temperature, mixer type, etc).