ALULOC-60 SR

ALULOC-60 SR

Characteristics: Low cement refractory castable, based on high quality bauxite and andalusite


Application:


Specific for the ALUMINIUM INDUSTRY.


Product specially designed for the lining of holding and melting furnace vessels in contact with molten aluminium, transfer and transport ladles and, generally, any other element where low wettability by molten aluminium and high thermal shock resistance is required.

Inicia sesión o regístrate para descargar la ficha técnica

Inicie sesión o regístrese para ver el precio y comprar

  • Insertec Technical Data Sheet
    Caracteristicas Low cement refractory castable, based on high quality bauxite and andalusite.
    Application Specific for the ALUMINIUM INDUSTRY. Product specially designed for the lining of holding and melting furnace vessels in contact with molten aluminium, transfer and transport ladles and, generally, any other element where low wettability by molten alumin
    Temperature 1100 ºC
    Grain Size Distribution 0 - 6 mm
    Tipo de Ligante Modified Hydraulic.
    Chemical Analysis AL2O3 Aprox :56,0% SiO2 Aprox : 34,0% Fe2O3 Aprox 1,0%
    Density 2600 Kg/m3
    Installation Cast-vibration with needle vibrators. Do not prepare more material than the amount to be installed within 20 minutes.
    Storage In a dry place, 12 months.
    Packing In 25 kg. paper sacks, over shrunk - wrapped pallet.
    Drying and Heating Follow specific instructions for each particular case. As a general rule: Hold for 24 hours before removing mould. Dry at 100-150 ºC for 12 - 36 hours. Heat up at a rate of 30 ºC/h. up to 450 ºC. Hold for 12 hours. Heat up to 600ºC at a rate of 30ºC/h an
    Water Required Casting and Vibrating 5 – 7 % (depending on mixing conditions: outside temperature, mixer type, etc).